Place around KC to get headers installed?

[quadcam]

I'll be honest, I'm just lazy. I could do this myself, but with living on post housing, I don't wanna tackle it without a driveway and with the limited amount of tools I have here. Back in Florida my extended family would have a 'community pot' way of using tools and I had an unlimited supply of stuff to use.

With all these factors considered, is there anywhere around here that would install mine without making me pay an arm and a leg?

[Buford]

You should have an onbase hobby shop? Every military base that I've been to have one. Lifts, tools, on site techs, etc. If not, there are quite a few shops in KC to tackle it. Without an aftermarket K-member, I would pay anyways. It can be a PITA

[quadcam]

You should have an onbase hobby shop? Every military base that I've been to have one. Lifts, tools, on site techs, etc. If not, there are quite a few shops in KC to tackle it. Without an aftermarket K-member, I would pay anyways. It can be a PITA

What sucks is that this is one of the very few posts in the entire US military that does not have a hobby shop. I was incredibly upset when I discovered that. I'm half tempted to mail the headers to the shop in Florida that's doing my cams.

[Buford]

What sucks is that this is one of the very few posts in the entire US military that does not have a hobby shop. I was incredibly upset when I discovered that. I'm half tempted to mail the headers to the shop in Florida that's doing my cams.

Why would you do that? Why don't you get it done locally?

[quadcam]

Why would you do that? Why don't you get it done locally?

Just to get it all done at the same time. I really don't know what I'm gonna do with them just yet.

[dane01cobra]

hey man i was looking at your list of mods and it looks good!!!! one thing though that i ran into this weekend is the underdrive pullies, if you ever decide to go the supercharger route, you just have to take them off and its just a slow down to getting boosted, good luck on the headers!!!

[quadcam]

hey man i was looking at your list of mods and it looks good!!!! one thing though that i ran into this weekend is the underdrive pullies, if you ever decide to go the supercharger route, you just have to take them off and its just a slow down to getting boosted, good luck on the headers!!!

Thanks for the compliments!! :)

I wanna go s/c someday, but it's gonna be a long time. A private's pay is a joke. :smilielol: Yeah, I figure it will be about two years. For now, I'm hoping to just get to 350rwhp n/a.

I can't wait to get my car up here so I can come to a KC Mustangs meet. :2up: :wave1:

[Napalm Tom]

MC Racing in Merriam can install them for ya.

[PSNOUS]

Mikes Performance in Blue Springs can call for a quote @ 816-694-0099